TCL scripts.
This is the UART RX TCL to run the test, record waves in VCD or SHM.
It is also used to put a break point in specman code , if required.
Execute some general commands, which are useful in debug like:
sn sh mod
sn trace objection on
#sn break on line 61 in @uart_byte
#sn break on error
#sn collect gen
#coverage
#sn read cover c_*.ucd
#sn sh cover mon_u
...
run
exit
Some VHDL design outputs many warnings in the initialization phase. This can be shut down by using the following commands from the TCL script:
## Disable assertion in the beginning to eliminate ECBI assertions at 0 FS
#assertion -off -all
#run 1ns
## Allow assertions again
#assertion -on -all
To go to main project: main project page
|
Search This Site
Feedback This Site
new pages on this site